Real Anchor Profi

Real Anchor Profi

by | Dec 22, 2015 | DesignFiX On Tour

Fixings of tensioned members in small components make particularly high demands on the engineer. The bearing capacity is reduced on all four sides by low edge distances. In addition, minimum dimensions of the concrete member must be observed in accordance with the...
Finite Element (FEM)

Finite Element (FEM)

by | May 10, 2015 | ETAG 001, FAQ / Knowledge Base

FEM calculation: Under the provision that a valid design result is present, a profile was selected and at least one anchor is tension loaded, you can use this function to determine the required base plate thickness according to the Finite Element Method (FEM)....
DesignFiX – 3D Anchor Design

DesignFiX – 3D Anchor Design

by | Apr 15, 2015 | FAQ / Knowledge Base

3D Anchor Design The 3D-Model shows your application including concrete component (base material), attachment, anchor layout, profile and loads. Based on this information a design is carried out for the selected anchor in real time at any change of the entered data...
Basis of the design

Basis of the design

by | Feb 9, 2015 | FAQ / Knowledge Base

Design method according to ETAG 001 + TR 029 The anchor design in DesignFiX is based on the European Technical Guideline published by the EOTA (European Organisation for Technical Approvals: Guideline for European Technical Approval of Metal Anchors for Use in...
DesignFiX – Status bar

DesignFiX – Status bar

by | Aug 12, 2014 | FAQ / Knowledge Base

DesignFiX – Status bar The status bar in DesignFiX provides you with important information about the result of the calculation and always refers to the currently selected product. Depending on the content of the window, the status bar can be multiline. The...